A New Process for the Drying and Gasification of Sewage Sludge

May 21, 2001

Sludge disposal

Gasification can completely sterilize sewage sludge while circumventing many of the problems commonly encountered with incineration.

In recent years, methods formerly used for the disposal of sewage sludge, including landfill, incineration, ocean dumping and disposal on agricultural land have become much less acceptable. Ocean dumping of sewage sludge has been outlawed in the United States since 1998. Space for agricultural land disposal is not available in many urban areas and is meeting with increased opposition from farmers largely because of concern over potential heavy metal contamination from sludge.1 Cost-effective and environmentally sound alternatives to existing means of sewage sludge disposal clearly are needed.

Gasification provides an attractive alternative to incineration for the thermal treatment of sewage sludge.2 Gasification is the thermal conversion of carbonaceous solids to combustible gas and ash in a net reducing atmosphere. This technique has all the advantages of incineration for sewage sludge treatment including complete sterilization of the sludge and reduction of mass to the minimum possible mass of ash. Moreover, gasification can circumvent problems commonly encountered with incineration such as the need for supplemental fuel, emissions of sulfur oxides, nitrogen oxides, heavy metals and fly ash and the potential production of chlorinated dibenzodioxins and dibenzofurans.3 These advantages are possible because gasification is a net chemically reductive process in contrast to incineration, which is oxidizing.4

The ChemChar hazardous waste gasification process is a cocurrent flow process in which solids, reactant gas (oxygen) and product gases all flow in the same direction through a continuous flow gasification reactor.5 Gasification of solids occurs in a relatively narrow thermal zone (i.e., the incandescent thermal zone [ITZ]) reaching temperatures up to an estimated 1,200° C that moves through a bed of granular solids in a direction counter to the flow of oxygen. (In a continuous-feed gasifier, the ITZ remains stationary and the solids are fed through the gasifier.) In a single pass of the ITZ through the solids, only about 20 percent of the solids are converted to gas leaving a carbonaceous (char) residue containing the mineral matter present in the sewage sludge. This char product has excellent properties as a drying and conditioning medium for the treatment of additional sludge to produce a mixture of char and sludge that can be gasified, thus completing a complete cycle of dewatering and gasification.

The ChemChar process has been demonstrated to be effective in destroying a wide variety of wastes, some of which have the potential to be present in biological waste treatment sludges. These include PCBs,6 surrogate military poisons7 and highly refractory chlorofluorocarbons.8 During gasification, sulfur is converted to hydrogen sulfide that can be readily removed from the gas stream9 and nitrogen is evolved as elemental nitrogen gas.10 A major advantage of this gasification system is complete retention of heavy metals on the char matrix. Although a fraction of mercury escapes the gasifier as mercury metal vapor, it is completely retained within the gasifier system.11


An experiment was devised where secondary digester sludge with a solids content of 7 percent (drying for two hours at 150° C) obtained from the Columbia, Mo., wastewater treatment plant was used throughout. Gasification was carried out in a 20 mm I.D., 40 cm-long Vycor (heat resistant silica) tube. The sewage sludge used to prepare the initial batches of char was dried for several days under an infrared lamp and ground and sieved to 20—8 mesh size. Carbon dioxide in the offgas was determined by collecting a measured volume of the offgas in a two-liter graduated cylinder initially filled with water and inverted in a plastic tub of water, registering the total volume of gas, then adding sodium hydroxide to the water to absorb carbon dioxide and measuring the volume of gas remaining. Drying studies were carried out on mixtures of one part sludge to two parts char by mass. Drying of sludge/char mixtures was conducted in a 25 mm I.D., 100 cm long Vycor tube at a flow rate of 4 L/min. Densities of solids were determined by pulverizing the solids with a mortar and pestle, then measuring the volume of a weighed amount of the pulverized solid packed into a graduated cylinder.


Furthermore, it was observed that the mixture resulting from drying sludge mixed with char gasifies well, producing significant quantities of combustible gas.

The dried granular sewage sludge gasifies very well with the system used. The condensate removed from the gas product has a strong odor, but is not a problem because it is recirculated through the gasification system to destroy the odor-causing contaminants. The dried gas product burns very well with a luminescent yellow flame that probably is indicative of a higher hydrocarbon content than the gas obtained by gasifying a char material such as that obtained from coal. Analysis of the gas product showed a 50 percent content of carbon dioxide, consistent with preceding gasification studies. The remainder of the gas product is combustible and, based on preceding gasification studies, probably consists of approximately equal quantities of carbon monoxide and elemental hydrogen with smaller, but significant, quantities of methane. This means that the gas product can be used as a fuel for applications such as powering a gas turbine to provide electrical energy for the wastewater treatment plant.

Forward-mode gasification in which the ITZ is initiated at the top, upstream end of the solids column and allowed to traverse to the bottom, completely consuming all combustible matter and leaving an ash residue, produces a combustible gas product consisting of 51.9 percent carbon dioxide. This gasification mode can be used to convert spent char used for sludge treatment to an ash product that can be safely disposed.

This was found to be the maximum ratio of sludge to char that could be used and still maintain air flow through a porous sludge/char mixture. It was observed that under the conditions used, drying is complete within 12 hours, reaching 89 percent of the level of drying attained by an additional two hours of drying at 150º C. The dried sludge/char mixture gasifies easily, with production of significant quantities of combustible gas and a char residue that can be recirculated through the drying process. It also was observed that the dried sludge/char mixture without gasification functioned equally well as a drying agent for additional sludge through at least two more cycles of drying. This provides a means of loading the mixture with additional gasifiable matter if needed for gasification to proceed.

With repeated cycles of drying, eventually ash will build up in the char product, requiring its disposal. When this occurs, the char can be subjected to a final gasification in the forward mode. This step produces an ash product with minimum volume and reclaims all fuel in the char.


A system has been described based on the gasification of sewage sludge that enables facile drying of the sludge and ultimately the reduction of the sludge to its ash content. The process requires no materials or supplemental fuel other than those obtained from the sludge itself and oxygen from air. A combustible gas product is generated that can serve as fuel in a gas turbine, thus providing the energy needed to extract oxygen from air. It is anticipated that commercial membrane processes can be used to extract oxygen, which does not need to be in a highly purified form. The ash residue, free of organics and pathogens with heavy metals sequestered in it, can be safely disposed.

For a list of references, visit our website at www.waterinfocenter.com.

Stanley E. Manahan is a professor in the Department of Chemistry at the University of Missouri in Columbia. Brendan McAuley and Julie Kunkel are students at the University of Missouri.

Leave A Comment

  • Web page addresses and e-mail addresses turn into links automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd>
  • Lines and paragraphs break automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.