NGWA Informs Water Well Owners About Flood Threats
NGWA provides steps to prevent, minimize or recover from well flooding
During this flood season, there are certain things household water well owners should know about how to protect their wells and their water quality, the National Ground Water Assn. (NGWA) said.
Flooding by surface water can threaten groundwater quality and the condition of a well system. The vulnerability of a well can vary depending on the area in which one's property is located or even the specific spot on a parcel of property where the well is installed, said Cliff Treyens, NGWA public awareness director.
Following are steps household well owners can take before, during and after a flood to prevent, minimize or recover from well flooding.
Before a Flood Threatens
Assess the water well to determine if it might be vulnerable to flooding. Considerations include:
- Wellhead location: Is it on high ground, which is least vulnerable to flooding; flat ground; or low-lying ground, which is most vulnerable to flooding?
- Construction: Is the well constructed to meet applicable codes or regulations, such as the proper height for the well casing and proper grouting of the well casing to minimize the potential for floodwater infiltration?
- Seals: Are the well system's sanitary seals intact to resist floodwater infiltration?
When Flooding Is Imminent
Ask a water well system professional what precautions should be taken, if any, to minimize the chances of floodwater entering the well. Also, well owners who are vacating their property due to flooding should shut off the power to the well pump before leaving.
After Well Flooding
- Household water well owners should call a contractor for an assessment of the well system.
- Arrangements for an alternative water supply, such as bottled water, should be made until the well has been cleaned, serviced, disinfected, tested and the water proven safe to drink.
- Well owners should not attempt to service their wells due to safety risks, including electrocution, and the potential to create more damage.
- Even under normal circumstances, proper disinfection of a water well can be difficult for the untrained. The proper type and amount of disinfectant, its distribution throughout the system, contact time with the water and well components, and the well's cleanliness can impact the effectiveness of water well disinfection.
- When a well is flooded, disinfection can become even more problematic due to the introduction of organic matter into wells, which can react with disinfectants to create disinfection byproducts that are considered a health risk.
- Flooding may cause debris to enter the well, requiring a thorough cleaning of the well system.
- Because floodwater can pick up some of whatever is on the ground surface — or contain substances that have spilled into the floodwater, such as chemicals in storage bins or tanks — disinfection of the water well may not be enough. Extensive pumping of the well and the aquifer may be required to eliminate contamination. After a flood emergency, check with local emergency officials or the county health department about any area-specific water testing that should be done.
For all these reasons and more, it is recommended a qualified water well system contractor should be engaged to inspect, service, clean and disinfect a well after a flood. Water testing should be done by a certified drinking water testing lab.
More Like This
- NGWA Recommends Steps to Take Before Using Flooded Water Wells
- NGWA Urges Water Well Owners to Address Abandoned Wells
- Best Practices for Flooded Water Well Disinfection Published
- Guidance Issued on Residential Water Well Methane Reduction
- Protect Your Groundwater Day Calls On Individuals to Focus On Water Issues